CNC machining · Dayton, Ohio
5-axis milling and Swiss turning in titanium, stainless and nickel alloys, built under an ISO 9001 and AS9100 certified quality system.
AS9100
The aerospace quality management standard, adding requirements for configuration control, risk management, first article inspection and counterfeit part prevention.
ISO 9001
Documented processes, internal audits, corrective action and continual improvement across quoting, machining, inspection and shipping.
MILL-5X
Complex housings, brackets, manifolds and implant components machined in one or two setups, so features stay true to each other without re-fixturing.
TURN-SW
Small, long and slender parts held to tight diameters along their full length: bone screws, pins, shafts, fittings and connector bodies.
Aerospace and implant-grade alloys with full material certifications and lot traceability.
Titanium
Ti-6Al-4V · Ti-6Al-4V ELI · CP titanium
Stainless steel
17-4 PH · 316L · 304 · 15-5 PH
Nickel alloys
Inconel 718 · Inconel 625
Aluminum
6061-T6 · 7075-T6 · 2024
Cobalt chrome
CoCrMo
Plastics
PEEK · Ultem · Delrin
Achievable tolerance depends on material, feature size and geometry. Send the drawing and we’ll confirm what we can hold before you commit.
| Feature | Typical | Applies to |
|---|---|---|
| Linear dimensions | To add | 5-axis milled features |
| Turned diameters | To add | Swiss-turned parts |
| True position | To add | Hole patterns and bores |
| Flatness | To add | Sealing and mating faces |
| Surface finish | To add | Ra, as machined |
| Smallest turned diameter | To add | Swiss turning |
Flight hardware and ground support parts built to AS9100, with first article inspection reports and full traceability from bar stock to shipment.
Implant and instrument components in titanium, stainless and PEEK, machined to the tight diameters and fine finishes device makers specify.
From quote to shipment, each part follows the same documented path, so what you approve at first article is what arrives on every lot.
Inspection equipment
Every RFQ and PO is checked for revision level, specs, flow-downs and critical characteristics before material is ordered.
Mill certs are verified on receipt and heat lots follow the job through machining, finishing and shipment.
AS9102 first article reports on new parts and revision changes, so you approve the process before production runs.
Characteristics are measured during the run and again at final inspection, with results recorded against the job.
Certificates of conformance, material certs and inspection reports ship with the parts.
Upload your drawing and we review it for manufacturability, tolerances and material before quoting.
Quote turnaround: To add: turnaround
Working under an NDA or ITAR controls? Note it in the form so we can handle your files accordingly.
Quote form goes here
Placeholder: connect a Tally or Typeform form with a file-upload field so buyers can attach drawings and STEP files.
To add: quote form link or quoting email